Gear Robot
Gear Robot
CIRCUIT CABLE 12V ….!? MY ROBOT
hello freinds I built a robot composed by four to 12 gears so that the Robot Moves forward when all engines are positive and vice versa.for turn left to the right of the robot consists of two engines are the same for positive and turn right on the left side the robot has two motors are positive ….. I have completed this robot through cables and now I'am planning to make a wireless network ….. can you please help me to get a simple wireless circuit I, which would control forward, backward, left and right operation, respectively ….. the engines (gear type) are 12V ….
You could control this way: an infrared diode wire serial port of your computer. An infrared detector wire serial to parallel converter (shift register, or 16550 UART). If desired, close the byte, until it reaches a new one. Use the 8-bit output in parallel to control engines through the transistor switches, wherein a motor means little on / off, and a little mean change direction. 2 bits per engine, engines 4 stroke = 8 bits. Look up "bridge h" for the array of transistors. Then just write software for the output byte right at the moment suitable for the serial port.
This entry was posted on Friday, March 11th, 2011 at 7:05 pm and is filed under Uncategorized. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.